Skip to main content

Elastomer Cable Compound Chart: EPR, EPDM, PCP, CSP, CPE, NBR, EVA and Silicone Explained

The letters on a rubber cable datasheet, and what each compound is chosen for.

Share

“Rubber cable” covers a family of different compounds, and the letters on a datasheet (EPR, PCP, CSP, NBR) say which one. Each compound is chosen for a particular job, some as insulation and some as sheath, and a flexible cable usually combines two of them. This chart explains the abbreviations and the general character of each compound. The properties are qualitative and depend on the formulation, so the datasheet for the cable governs.

Compounds at a glance

AbbreviationMaterialUsual roleGeneral strengthsGeneral limits
EPR, EPDMEthylene propylene rubberInsulationGood electrical properties, flexibility, resistance to heat, ozone and weather, low sensitivity to water treeingPoor resistance to mineral oil, so it is normally protected by a tougher sheath
PCPPolychloropreneSheathTough, resists abrasion, weather and flame, moderate oil resistanceContains chlorine, so it is not a halogen-free material
CSPChlorosulphonated polyethyleneSheathResists ozone, weather, heat, oils and many chemicalsContains chlorine, so it is not a halogen-free material
CPEChlorinated polyethyleneSheathResists oil, weather and flameContains chlorine, so it is not a halogen-free material
NBRNitrile rubberSheath, often blended with PVCStrong resistance to oils and fuelsWeaker against ozone and weather unless blended
EVAEthylene vinyl acetateInsulation or sheathHeat resistance, and a common base for low-smoke halogen-free compoundsMechanical toughness depends heavily on the formulation
SiliconeSilicone rubberInsulationStays flexible over a very wide temperature rangeLower mechanical toughness and cut-through resistance than other rubbers
VIR, TRSVulcanised rubber insulation, tough rubber sheathInsulation and sheathFlexible, long-established general-purpose compoundsLimited resistance to heat, oil and ozone compared with synthetic rubbers

How insulation and sheath are paired

The insulation is chosen for its electrical behaviour and the sheath for the environment. A common pairing is ethylene propylene rubber insulation under a polychloroprene or chlorosulphonated polyethylene sheath: the insulation handles the voltage and the heat, and the sheath handles abrasion, oil and weather. Where oil is the main hazard, a nitrile-based sheath is considered. Where a cable must stay flexible at temperature extremes and is not dragged or crushed, silicone is the usual choice. Where smoke and acid gas in a fire are the concern, the chlorine-bearing sheaths are avoided and a halogen-free compound is specified instead.

What to tell the manufacturer

  • Fixed, occasionally flexed or continuously moving duty.
  • The oils, fuels or chemicals the cable will meet.
  • Outdoor exposure to sunlight and ozone.
  • The minimum and maximum temperatures at the cable.
  • Whether a halogen-free or low-smoke sheath is required.
  • The standard the project is tendered against.

APAR elastomer cables

APAR states that it has in-house compounding for VIR/TRS, EPDM, silicone, CSP, PCP, NBR and EVA compounds, and that it uses electron beam technology in this range. The EPR, EPDM, CPE, CSP and silicone polymer cables page lists IS 9968 Part 1 for LV cables, IS 9968 Part 2 for MV cables and IS 14494 for trailing cables among the applicable standards, with a range of 0.5 to 500 sq mm in single core. Related elastomer products include APAR welding cables, mining cables and material handling and trailing cables.